About Main Equipment Restore

Studying find out how to change your dryer belt may help prevent cash. You do not have to be a do-it-yourselfer to placed on a brand new dryer belt. It’s fairly a standard restore, and you will solely want a couple of instruments to do it. You may want: Phillips screwdriver, putty knife, 5/16 socket or nut driver, and a small container for the screws. This text will clarify find out how to change a dryer belt, for the fashions with the lint filter on high.

In case your dryer has the lint filter on the highest, right here is the best way to exchange the belt. The very first thing you need to at all times do earlier than performing repairs on any equipment is unplug the unit from energy. Not doing so might end in extreme damages to your self and your equipment. Slide out your lint filter, and take away the 2 screws which might be uncovered. Subsequent, take your putty knife and slide it below the highest of the dryer, pop up the highest by lifting up on the left and proper corners on the entrance of the dryer. Then elevate up the highest, flip it again, and prop it on a wall for those who can samsung dryer repair los angeles.

Now that the within of the dryer is uncovered, you have to to take away the entrance panel to get to the belt. There are two screws you have to take away to take off the entrance panel, and they’re positioned on the left and proper inside corners. As soon as the screws are taken out, you possibly can elevate off the entrance of the dryer. Typically you may must take away the door swap to fully take away the entrance.

Now you possibly can take away your outdated belt. Chances are you’ll want one other particular person that can assist you to carry up the drum for this half. Take out your new belt, and place it over the drum with the grooves touching the drum, make sure that it isn’t twisted in any other case it would simply fall off when you begin your machine. Subsequent, you may must get below the drum the place the motor and pulley are positioned. The belt might want to undergo the pulley, and hooked up to the motor shaft. If this was carried out accurately, the pulley will apply pressure to the belt.

Now you are carried out with the set up of your new dryer belt. And to complete you may must re-assemble your dryer. Once you put again the entrance panel of your machine, make sure that the tabs on the underside are lined up with the panel itself, it ought to simply snap into place. Substitute the screws on the within proper and left corners, then flip the highest of the dryer again down. This must also snap again into place. Then simply put again the screws on the highest the place the lint filter goes, and slide the lint entice in. The very last thing is to plug in your dryer, and you will be again in enterprise.

Leave a Reply

Your email address will not be published. Required fields are marked *